Keep integrations running efficiently by configuring performance and storage settings for your serverless runtime environment. You can update these settings while the runtime environment is running.
Modify Secure Agent service properties
Modify Secure Agent service properties to optimize performance or to apply settings that Informatica Global Customer Support recommends.
On the Runtime Configuration tab of the serverless runtime environment, update service properties or add custom properties. To reset all Secure Agent service properties to their system defaults, select Reset All.
For more information about the Secure Agent services and their properties, see Secure Agent Services.
Set the number of simultaneous tasks
By default, a serverless runtime environment can run up to 150 tasks at the same time.
To lower the limit, edit the maxDTMProcesses property on the Runtime Configuration tab of the serverless runtime environment. Filter the list by setting the service to Data_Integration_Server and the type to Tomcat. You can set the property to any value between 1 and 150.
Configure where Data Integration reads and writes files
Set default directories to configure where Data Integration reads and writes files, such as source files, target files, and temporary files.
To update a directory, edit the appropriate system variable on the Runtime Configuration tab of the serverless runtime environment. Filter the list by setting the service to Data_Integration_Server and the type to PMRDTM_CFG.
Note:
Directory names can't contain the following special characters: * ? < > " | ,
The following table describes the system variables:
System Variable
Description
$PMLookupFileDir
Directory for lookup files. Default is $PMRootDir
$PMBadFileDir
Directory for reject files. Default is $PMRootDir/error
$PMCacheDir
Directory for index and data cache files. Default is $PMRootDir/cache
$PMStorageDir
Directory for state of operation files, used for recovery in high availability or recovery-enabled workflows. Default is $PMRootDir
$PMTargetFileDir
Directory for target files. Default is $PMRootDir
$PMSourceFileDir
Directory for source files. Default is $PMRootDir
$PMExtProcDir
Directory for external procedures. Default is $PMRootDir
$PMTempDir
Directory for temporary files. Default is $PMRootDir/temp