Adabas CDC Connector Guide > Introduction to Adabas CDC Connector > Task flow for using Adabas CDC Connector
  

Task flow for using Adabas CDC Connector

To use Adabas CDC Connector, create a source connection, mapping, and mapping task. Also create a target connection if one is not already defined.
Before you begin, in the Administrator, you must complete the prerequisite tasks. See Prerequisite tasks for using Adabas CDC Connector for more information.
    1In Administrator, create a source connection with the type of Adabas CDC. Test the connection.
    Alternatively, you can create a source connection in Data Integration when you configure a mapping.
    Adabas CDC Connector uses this connection to retrieve source metadata and change data records from PowerExchange.
    2Create a target connection that has a supported target type, if one is not already defined.
    3In Data Integration, configure a mapping. Validate the mapping and then save it.
    4Create a mapping task that is associated with the mapping.
    You can set optional CDC runtime properties and advanced session properties. For more information, see CDC runtime properties in mapping tasks and Advanced session properties in mapping tasks.
    5Run the mapping task manually, or create a schedule to run it on a recurring basis. For more information, see Running a mapping task.
    6Monitor the job status for the mapping task instance. For more information, see Monitoring a mapping task.
    If a job has the status of Failed or Warning, check the session log for related error or informational messages. Then try to correct the issues that caused the failure and restart the mapping task from the appropriate point in the change stream.