SAP BAPI Connector Guide > SAP BAPI Connections > Basic connection properties
  

Basic connection properties

The following table describes the basic properties that you can configure on the Properties tab of the connection creation page:
Property
Description
Name
Required. Unique name for the SAP BAPI connection that identifies it in the Process Designer. The name must start with an alphabet and can contain only alphabets, numbers, or hyphens (-).
Location
The location of the project or folder where you want to save the connection. Click Browse to select a location.
If the Explore page is currently active and a project or folder is selected, the default location for the connection is the selected project or folder. Otherwise, the default location is the location of the most recently saved asset.
Description
Optional. Description of the connection.
Type
Required. The type of connection you want to use for the connector or service connector. Select SAP BAPI.
Run On
Required. The name of the Secure Agent group or the Secure Agent machine where the connection must run.
Connection Test
Indicates whether the connection test was successful or not. By default, the property displays the results of the connection test.
OData-Enabled
Not supported for SAP BAPI Connector.
Along with these basic properties, you must define the properties applicable to the SAP BAPI connection type.
The Metadata tab displays the process objects generated when you publish the SAP BAPI connection.