Test a labeler asset to verify that the data flows through the asset in the ways that you expect. You can test all of the steps in the asset or a subset of the steps.
1Open the labeler asset.
2Select the Configuration tab.
3Select a step in the step sequence.
The test runs on the steps in the asset and ends with the step that you select. The test runs in the order that the step sequence specifies.
4 Select a Secure Agent to run the test.
To refresh the list of active Secure Agents, click the Refresh icon.
5Enter one or more data values in the input column, or import the data to test. To import the data, click the Import option in the test panel.
6Click Test.
The test results contain the following columns:
Labeled Output
A copy of the input string in which values that match the label criteria are replaced with the label that the steps define.
Tokenized Data
A copy of the input string. If you selected the Standardization option in a dictionary step, the test replaces any input value that matches the label criteria with the corresponding value from the valid column in the dictionary.
7Verify that the steps read the input values and write the output values that you expect.